top of page

Polywood code 208

Polywood code 210

Polywood code 311

Polywood code 208
1/7

Polywood Catalogue
Polywood Catalogue 1

Polywood Catalogue
Polywood Catalogue 2

Polywood Catalogue
Polywood Catalogue 4

Polywood Catalogue
Polywood Catalogue 1
1/4
Installation conditions
-
Rezopal should be drilled with a 2 or 2.5 drill bit before screwing and then screwing.
-
It should be cut after drilling with 12 drill bits on 4 sides before cutting the washer and gas.
-
There should be at least 1 rack every 1 meter.
-
Before the washer is installed, the HPL must be sealed with silicone so that water cannot seep between the HPL and the polywood.
-
It is recommended to cut the rhizopal from the lower part.
-
The jigsaw must be sharp.
Polywood
bottom of page